Newbie
BytesHosts
Posts: 9
Registered: ‎09-12-2012
Posts: 9
Registered: 09-12-2012

How to configure Nanostation, Loco as a AP

Hello

There are some simple steps to configure your NanoStation and Loco as a simple AP and AP in Router Mode.

Simple steps are mentioned here: wiki.ubnt.com/Simple_AP_Setup

But if you want to setup your NanoStation In Route Mode

In Wireless Tab, set:

    WLAN Network Settings
  • Wireless Mode: Access Point
  • SSID: yourSSID (or any other string to identify your WLAN)
  • Country Code: set according your country
  • IEEE 802.11 Mode: B/G/N mixed
  • Channell Spectrum Width: 20MHz (Very important if want to connect Mobile and Laptop with your WLAN)
  • Channel: Auto
  • Output Power: 10 dBm (or check Obey Regulatory Power according your country law - but I use 11 dBm normally)
  • Data Rate, Mbps: 54, Auto
  • Security: WPA (or any other, supported by Wireless Client)
  • WPA Preshared Key: yourpassphrase (this is a secret key for your WLAN, minimum 8 printable ASCII chars, maximum 63)
  • Click "Change"
  • Wait until process is complete and click "Apply" to confirm new configuration (or click "Discard" to refuse).


Uncheck AirMax (Very Important)

In Network Tab, set:

  • Network Mode: Router
  • IP Address: 10.10.10.20
  • Netmask: 255.255.255.0
  • Enable DHCP Server: Check
  • Range Start: 10.10.10.10
  • Range End: 10.10.10.19

    Lan Network Setting:
  • Lan IP Address: DHCP
  • DHCP Fallback IP: 192.168.1.20
  • DHCP Fallback NetMask: 255.255.255.0
  • Click "Change"
  • Wait until process is complete and click "Apply" to confirm new configuration (or click "Discard" to refuse).


Screen Images attach here forum.ubnt.com/showpost.php?p=352866&postcount=13