Note:The ER-X/ER-X-SFP/EP-R6has more limited storage, and in some cases, an upgrade may fail due to not enough space. If this happens, remove the old backup image first (using "delete system image" command, seeherefor more details) before doing an upgrade.
More details can be found in the release notes below. Please give it a try if you are interested in the new features/changes to help us test them so that we can get the release out sooner! Thanks very much!
Changes since v1.10.7
Enhancements and bug fixes:
[System] - Add support for new fanHWintroduced in new ER-8-XGhardware revision
[LoadBalancing] - Fix bug whenLoadBalancingwould not recover if failed interface restores link after being down for a long time (more than an hour)
[Bootloader] - Fix bug whenbootloaderpartition was randomly erased duringbootloaderupgrade on ER-4/ER-6P/ER-12 models (very-very unlikely but still possible). Discussed here
[LED] - Fix wrong "locate" LED functionality on ER-12
[LED] - Update system LED notification for ER-8-XGmodel (requiresbootloaderupgrade)
[FAN] - Improve fan control on ER-8-XGmodel (requiresbootloaderupgrade)
[Offloading] - Fix bug when "showubntoffload flows" caused router to crash if offloading was disabled
[CLI] - Fix incomplete "dhcpv6-server preference" help message
[Routing] - Fix bug when staticECMProutes from custom routing tables would not be restored whennexthopinterface flaps. Discussedhere
[DHCP] - Fix bug whenDHCPclient failed to restoreIPv4address after interface link flap ifIPv6address was configured on same interface
[ER-Lite/ER-PoE] - Fix incorrectlycalculated size of flash storage in boot log (this is purecosmetic fix and does not affect any functionality).
[ER-8-XG] - Fix incorrectLED light behavior during boot
[ER-8-XG] - Improve FAN control logic for some earlier hardware builds during boot
Note: Latest bootloader is stored inside EdgeOS firmware since v1.10.7. You can check currently installed bootloader version with "show system boot-image" CLI command and then upgrade it with "add system boot-image" CLI command .