Note: The ER-X/ER-X-SFP/EP-R6 has more limited storage, and in some cases upgrade may fail due to not enough space. If this happens, remove the old backup image first (using "delete system image" command, see here for more details) before doing upgrade.
More details can be found in the release notes below. I would like to thank everyone for their participation in the community, as always helping with testing, reporting issues, providing feedback, suggestions! We certainly could not have done it without you Thank you very much!
[Release Notes v1.9.1]
Changes since v1.9.0
[FW Update] Add automated firmware update check. This is just a first step in providing automated firmware updates and current functionality only checks for update but does not download actual firmware. Complete automatic firmware update funtionality will be provided in future release.
Enhancements and bug fixes
[Web UI] Fix bug when app categories were not showing up in basic queue in safari. Discussed here
[Web UI] Fix EdgeOS compromise due to XSS in encoder error handling
[Web UI] Fix IP address validation bug in "Load Balancing2" wizard
[Web UI] Fix broken dashboard in Firefox. Discussed here
[Web UI] Fix bug when "Basic Setup" wizard with dhcp & vlan generates wrong NAT config. Discussed here
[BGP] Fix bug when "ribd" was constantly consuming 10% CPU with full BGP routing table. Discussed here
[Routing] Fix random "nsm" daemon crash when multiple interfaces flap simultaneously. Discussed here
[Routing] Fix incomplete default gateway when pppoe link fails. Discussed here
[Routing] Fix bug when "ribd" was sometimes stuck consuming 100% CPU after link to default gateway failed. Discussed here
[Routing] Fix bug when "set ip-next-hop x.y.z.w" route-map CLI command had no effect
[Routing] Fix bug when "show ip route" CLI command was showing "Network not in table" error instead of default gateway
[Routing] Fix bug when custom routing tables sometimes were not populated after boot. Discussed here
[IPSec] IPSec ofload on ER-X/ER-X-SFP/EP-R6 platforms is causing packet corruption of L2TP and IPV6 site-to-site VPN traffic. Discussed here and here. If you are using either L2TP or IPv6 site-to-site VPN then you should disable IPSEc offload:
set system offload ipsec disable
[Interfaces] The auto-negotiation of SFP port on ER-X-SFP and EP-R6 is changed to enabled by default. Discussed here. This change may affect the SFP link. If you need fixed 1000/full on eth5, please configure it via CLI:
set interfaces ethernet eth5 speed 1000
set interfaces ethernet eth5 duplex full