EdgeMAX EdgeSwitch X software release v1.1.0

by Ubiquiti Employee on ‎11-02-2018 10:17 AM - last edited on ‎12-03-2018 08:15 PM by Ubiquiti Employee

We released new version of the EdgeSwitch X firmware today which addresses some issues present in the initial firmware release and adds new features.

You can download it from https://dl.ubnt.com/firmwares/edgemax/EdgeSwitchX/v1.1.0/ESX.1.1.0.bix
(SHA256: 7203ab4fa47f4cf1d56968e7837998d1dca5f9d00666ae0fa679de51b4ac4f73)
Note: This firmware is only for EdgeSwitch X models ES-10X and ES-10XP, not for legacy EdgeSwitch XP devices (formerly known as TOUGHSwitch).

List of changes since firmware release v1.0.0:

  • Added port rx/tx rate limiting.
  • Added factory reset via UI.
  • Added cable test.
  • Added jumbo frames toggle (10 kB).
  • Added configurable ping watchdog timeout.
  • Added support for 10/100 Mbps speed with UF-RJ45-1G SFP module.
  • Discovery tool improvements (vendor names, discovery results in MAC list).
  • Discovery responds to IPv6 probes.
  • Fixed discovery responder responding on non-management VLANs.
  • Fixed SSH login (ACL verified by standard OpenSSH's password authentication method).
  • Fixed minor issues in system LED indication.
  • Fixed firmware upgrade from UNMS.
  • Fixed backup and restore from UNMS.
  • Fixed broken SSH after config restore.