Reply
Highlighted
Member
Posts: 141
Registered: ‎04-18-2016
Kudos: 21
Solutions: 2

DC module not operational?

[ Edited ]

I'm assuming this a bug but when I test my DC module by making it primary it shows the battery voltage dropping.  The GUI however says that the DC module is not operational?  I'm trying to make sure this site will work when the power dips out.

 

edit: The DC module is wired into 2 deep cycle batteies in series.  They are cheaper ones from rural king if that matters.

here is the log:

 

Spoiler
SYSTEM LOG
Close
Nov 13 14:12:18 system: Start
Nov 13 14:12:19 FileSystem: Start check...
Nov 13 14:12:23 FileSystem: End check.
Nov 13 14:26:41 system: Stop
Nov 13 14:26:47 system: Start
Dec 04 13:27:27 system: Stop
Dec 04 13:27:33 system: Start
Dec  5 10:05:03 syslogd started: BusyBox v1.11.2
Dec  5 10:05:03 syslogd exiting
Dec  5 10:05:03 syslogd started: BusyBox v1.11.2
Dec  5 10:05:13 psu-monitor[397]: PSU#0 [AC] status: enabled, operational, standby - enabled
Dec  5 10:05:13 psu-monitor[397]: PSU#1 [DC] status: disabled, non-operational, standby - disabled
Dec  5 10:05:13 psu-monitor[397]: PSU#1 [DC] battery[2] is non-operational; voltage: 25.650V, temperature: 10C
Dec  5 10:05:21 init: reloading /etc/inittab
Dec  5 10:05:54 init: reloading /etc/inittab
Dec  5 10:06:13 psu-monitor[397]: PSU#0 [AC] status: enabled, operational, standby - enabled
Dec  5 10:06:13 psu-monitor[397]: PSU#1 [DC] status: disabled, non-operational, standby - disabled
Dec  5 10:06:13 psu-monitor[397]: PSU#1 [DC] battery[2] is non-operational; voltage: 25.650V, temperature: 10C
Dec  5 10:07:13 psu-monitor[397]: PSU#0 [AC] status: enabled, operational, standby - enabled
Dec  5 10:07:13 psu-monitor[397]: PSU#1 [DC] status: disabled, non-operational, standby - disabled
Dec  5 10:07:13 psu-monitor[397]: PSU#1 [DC] battery[2] is non-operational; voltage: 25.650V, temperature: 10C
Dec  5 10:08:14 psu-monitor[397]: PSU#0 [AC] status: enabled, operational, standby - enabled
Dec  5 10:08:14 psu-monitor[397]: PSU#1 [DC] status: disabled, non-operational, standby - disabled
Dec  5 10:08:14 psu-monitor[397]: PSU#1 [DC] battery[2] is non-operational; voltage: 25.650V, temperature: 10C
Dec  5 10:09:14 psu-monitor[397]: PSU#0 [AC] status: enabled, operational, standby - enabled
Dec  5 10:09:14 psu-monitor[397]: PSU#1 [DC] status: disabled, non-operational, standby - disabled
Dec  5 10:09:14 psu-monitor[397]: PSU#1 [DC] battery[2] is non-operational; voltage: 25.650V, temperature: 10C

edgepower.png

Reply