Reply
New Member
Posts: 23
Registered: ‎07-18-2014
Kudos: 3
Accepted Solution

Apply Firewall Policy to Bond0 vif

I have a brand new EdgeRouter Pro running the latest firmware (first thing I did). I created an 802.3ad bond interface Bond0 and then I created a couple vifs for various VLANs on bond0 and then I created a firewall policy. When I try to apply the firewall policy to the bond0.98 interface the GUI hangs. It just sits there spinning. In the CLI I tried this command: set interfaces bonding bond0 vif 97 firewall in TEST_IN

But it says the specified configuration node is not valid...what am I missing? Can I not do this?


Accepted Solutions
Previous Employee
Posts: 13,551
Registered: ‎06-10-2011
Kudos: 5465
Solutions: 1656
Contributions: 2

Re: Apply Firewall Policy to Bond0 vif

That sounds like a bug in the GUI and we'll look into and address it. Thanks for reporting the issue!

View solution in original post


All Replies
Highlighted
New Member
Posts: 23
Registered: ‎07-18-2014
Kudos: 3

Re: Apply Firewall Policy to Bond0 vif

ahh I forgot the keyword "name"

It works if I use the CLI but if I use the GUI it just hangs.

Previous Employee
Posts: 13,551
Registered: ‎06-10-2011
Kudos: 5465
Solutions: 1656
Contributions: 2

Re: Apply Firewall Policy to Bond0 vif

That sounds like a bug in the GUI and we'll look into and address it. Thanks for reporting the issue!

Reply