Reply
New Member
Posts: 5
Registered: ‎02-13-2019

Edge lite Speed issue

I have a EdgeRouter Lite v1.10.7 with Verizon FIOS 1gig service. I have a cat6 cable from the ONT to the Router yet wired speed out of the router is 150-200mbps. When I hadline test the ont driect to the Computer I am getting 956mbps/904mbps.  As soon as the ONT plugged into the router and I hardwire to the router I get cut down to 200 or less. I have LAN1 on Eth0 and ONT on ETh1.

 

I have no special settings other then forwarding, I have traffic analysis off.. and firmware is current. Anyone have any Idea why I would be getting a fraction of the connection when I route through this router .  Oh I also tested the ONT through a Nighthawk X10 and the speed was in the 800's

SuperUser
Posts: 8,489
Registered: ‎01-05-2012
Kudos: 2239
Solutions: 1132

Re: Edge lite Speed issue

Did you enable the offload ?

Cheers,

jonatha

New Member
Posts: 5
Registered: ‎02-13-2019

Re: Edge lite Speed issue

I did not, I had a very hard time figuring out how to even set this router up to start with.... I see the command .  set system offload ...   is there some variable I should be putting in where the ... is ?

 

SuperUser
Posts: 8,489
Registered: ‎01-05-2012
Kudos: 2239
Solutions: 1132

Re: Edge lite Speed issue

Try this, connect via SSH and issue

Spoiler
configure
set system offload ipv4 forwarding enable
commit;save

Then, reboot the router, and check the throughput. Basically, you should enable the offload for the features that you use, the above should work, but if eg, you have pppoe on the wan, you may need to enable the offload on pppoe as well, as in the linked article (in the Cavium section).

Cheers,

jonatha

 

New Member
Posts: 5
Registered: ‎02-13-2019

Re: Edge lite Speed issue

i can not get ssh in for some reason. how would I do it from CLI.. no matte how I enter it into CLI it fails. i cant put it on multiple lines and It doesnt work when you put it in as one string. 

SuperUser
Posts: 8,489
Registered: ‎01-05-2012
Kudos: 2239
Solutions: 1132

Re: Edge lite Speed issue

Try with the config-tree, system, offload, ipv4, forwarding, enable, save and reboot

Member
Posts: 142
Registered: ‎10-02-2015
Kudos: 16
Solutions: 9

Re: Edge lite Speed issue

in the cli tab in the gui. You have to do each line command follow by pressing "enter" to submit the command.

New Member
Posts: 5
Registered: ‎02-13-2019

Re: Edge lite Speed issue

That helped a little. but still losing a lot. It went from 200/200 to 677/340 . i have 1g/1g so seems to be alot being lost somewhere with this router. 

SuperUser
Posts: 8,489
Registered: ‎01-05-2012
Kudos: 2239
Solutions: 1132

Re: Edge lite Speed issue

Why you don't try with the 1.10.8 firmware ?

Member
Posts: 142
Registered: ‎10-02-2015
Kudos: 16
Solutions: 9

Re: Edge lite Speed issue

[ Edited ]

Is there a software bridge?  Such as eth1 and eth2 being bridged together

 

also tried the ipv6 fowarding also

do you have any vlans?

Reply