Reply
New Member
Posts: 28
Registered: ‎05-27-2015

Setting up my first fail over network!

[ Edited ]

Good Afternoon Everyone! 

I just got my new Edge Router X In the mail today. I started to set it up and felt a little overwalmed for some reason. So i thought i would post my config here before implementing it and see what everyone thought. 

 

Please see attachment. 

config.jpg
network map router.jpg
Veteran Member
Posts: 7,600
Registered: ‎03-24-2016
Kudos: 1977
Solutions: 871

Re: Setting up my first fail over network!

For sure you'll run into problems:

In top image, I see 2 interfaces with same IP address

New Member
Posts: 28
Registered: ‎05-27-2015

Re: Setting up my first fail over network!

[ Edited ]

Correct. The reason for this is because one is a hard line connection though fiber and the other is a wifi fail over. They go to the same place just a different rout. 

I guess i can change the Wifi network to another Vlan with its own ip and solve the problem?

Or would i need all three interfaces to be different ip asignments? 

 

I should probably mention i do not want any loadballancing options enabled this is a 100% fail over option only. 

Reply