Reply
New Member
Posts: 35
Registered: ‎06-15-2015
Kudos: 2
Solutions: 1

UPNP dual wan

I have client that has to use UPNP.. His CPE is in route mode with 192.168.x.1/24 local address and 192.168.1.x/24 as WAN address. I have load-balance between pppoe0 (eth0) and pppoe1 (eth1) interfaces with dinamic IP address changed every 24hrs by ISP, and switch0 (eth2, eth3, eth4). Router is ER-X with 1.10.1 FW.

I tried few configs trought wizard, config tree and CLI found already discussed on this forum, but nothing works.

Ubiquiti Employee
Posts: 2,752
Registered: ‎05-08-2017
Kudos: 483
Solutions: 398

Re: UPNP dual wan

Can you provide your (sanitized) configuration? The currrent UPnP(2) implementation only allows you to specify a single WAN interface.

 

Ben

 


 

Ben Pin | Ubiquiti Support

New Member
Posts: 35
Registered: ‎06-15-2015
Kudos: 2
Solutions: 1

Re: UPNP dual wan

Sure, but later. Is it possible to 'stick' IP/client to specific WAN to force him always to use WAN with UPNP enabled?

Reply