10-16-2016 01:27 PM
I have a new ER-X EdgeRouter X that will not reset to 220.127.116.11
I have pc in eth-0 and no k
Tried power on reset and power unplugged reset nothing worked
I am new so I maybe missing something basic
10-16-2016 02:50 PM
set your PC to 192.168.1.2 with the subnet mask 255.255.255.0 and gateway 192.168.1.1
Then with the PC plugged into eth0, the ER should respond if you ping 192.168.1.1 (or open a webbrowser and navigate to https://192.168.1.1).
Note that these devices take about 5 minutes to boot after you've done a factory reset on them.
10-16-2016 04:25 PM
well, you "can" manage it from the internet, but that's generally a bad idea.
Once you finish running the configuration wizard (and reboot when prompted), it'll listen on ports 1,2,3,4 for additional configuration.
10-27-2017 01:13 PM
Glad that I found this, was facing the same issues:
<Note that these devices take about 5 minutes to boot after you've done a factory reset on them.>
It would be great that the Quick Start Guide would mention this, and / or the leds would blink in particular way while the device is re-booting.