Reply
Highlighted
Emerging Member
Posts: 42
Registered: ‎05-30-2011
Kudos: 6

Edgeswitch VLAN Setup

I am a switching newbie so please understand that this might be a fairly basic question.

 

So here is the scenario; I have an edgemax 24 port switch in which I have some of my AP's connected. I want to send a DSL line through the system to a single client... so I would like to connect that DSL line to port "12" which will then be tagged as VLAN 7. At the clients CPE I want to untag it. The config. on the CPE end seems straight forward but I am bogging down a little on the switch side and cant seem to make it work. Any pointers?

-Thanks!

Established Member
Posts: 842
Registered: ‎07-25-2015
Kudos: 125
Solutions: 39

Re: Edgeswitch VLAN Setup

Look at these support pages; 

https://help.ubnt.com/hc/en-us/articles/205197630

https://help.ubnt.com/hc/en-us/sections/201202327-EdgeSwitch

You will find these under the main support page

 

https://help.ubnt.com/hc/en-us/categories/200321064-EdgeMAX

 

Cheers,

 

Mike

If the feedback solved your problem or question. Please mark it as solved. If it is worth some Kudo’s don’t forget to give some :-)
Reply