Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×
Reply
Highlighted
Ubiquiti Employee
Posts: 405
Registered: ‎01-23-2015
Kudos: 249
Solutions: 33

Firmware 1.0.4 release

Firmware 1.0.4 is released, primarily addressing the display issues with any time zone transition.

 

  • Fixes data display issue for post-daylight saving time transition.  The daemon running on the gateway will have to go through the stored data and fix an error in the timestamps. This could take a few minutes after the first boot, resulting in slow responses in the GUI.
  • Time zone updates: There were many superfluous time zones, we've trimmed those out to a list that's more manageable.
  • Allow control over how much detailed data is kept.  Default is 62 days, then data gets aggregated to daily data.  If you'd like to keep more detailed data, you can increase the value in /etc/solar_agent/solar_agent.conf, however it's possible to lose data if the device runs out of space.  Depending on how many panels an installation has, this value could safely range from 90 to 3650 (or higher). The new section in the configuration looks like this:

 

################################# Aggregation ##################################

## Number of days to keep detailed data
## Defaults to: 62, set to None to keep all files
#DETAILED_LIMIT = 62

################################################################################
  • Regions update: A couple regions needed updates to the certification parameters.
  • Inverter firmware: A new inverter firmware is included in this gateway release.  Inverters will automatically be updated as needed.  This addresses an issue where inverter were overly-cautious during small spurious AC line disturbances and would shut off.

There are a few minor display issues that I'd like to fix, but please post if you run into any difficulties!

Reply