Member
Posts: 201
Registered: ‎04-03-2017
Kudos: 157

Curios Issue With UNMS when router is in Load Balancing mode

So, recently I made a changed to one of my gateway routers, in that Spectrum only allows a single /27 subnet attached to a modem.  so I had to get a 2nd modem, and thus, essentially, I have "2 WANS" and have the Edge Router Pro in load balance mode.  But now, my UNMS doesn't show that the router is connected to the internet anymore?!?!  Any suggesions?

Member
Posts: 201
Registered: ‎04-03-2017
Kudos: 157

Re: Curios Issue With UNMS when router is in Load Balancing mode

(I actually just figured it out on my own

Ubiquiti Employee
Posts: 3,430
Registered: ‎09-08-2017
Kudos: 1319
Solutions: 259

Re: Curios Issue With UNMS when router is in Load Balancing mode

Hello @HyperFusion. Kudos for you, for solving the issue. I would like to encourage you to share the solution you found, in case other users came upon the same situation.  

UBNT_Alternate_Logo.png
UNMS Support - If you want to report an issue please use this guide.

Check out our ever-evolving Help Center for answers to many common questions!

Highlighted
Member
Posts: 201
Registered: ‎04-03-2017
Kudos: 157

Re: Curios Issue With UNMS when router is in Load Balancing mode

Yes, of course, in UNMS, if you click on the data link button on the back side when your in site view you can "link it to the internet" but only from that view for what ever reason, you can't do it in topolgy view or map view.  Sorta aggrivating, I thought it was cause of load balance mode but it had nothing to do with it.