Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×
New Idea

Allow Controller to run on a Single IP Address

Submitted by -

Currently, as per the discussions in this thread, the controller binds to all IP addresses available on the host system. The port the server runs on is already configurable through the system.properties file, however the IP address is not (system_ip= is not used for this purpose). Currently therefore, the controller binds to the same port on every IP address.

I propose that the IP address be made configurable to bind to only a single IP if required. This would allow the the controller to run on say port 443 whilst another service, such as a web server, was also listening on port 443 on another IP address.

 

 

Duplicates
http://community.ubnt.com/t5/UniFi-Feature-Requests/Bind-Unifi-controller-to-specific-IP-addres-ses/idi-p/696521