0 Kudos

[Feature Request] checkbox in GUI for VPN Routing by 2 WAN with Load balance

Submitted by -
Status: New Idea

Hello everybody,
following problem:
I can set up WAN1 and WAN2 completely via GUI.
I can also set up the load balance for both WAN via GUI
I can set up VPN via GUI.


But I would like the VPN at Load Balance works, I have to very little on script the configuration change. By the way, if WAN2 is configured as a fall over, also VPN works.


Here are the help topics to describe the procedure what I have to do for this function, what I got from the support.


You can use the Weighted LB and route the VPN only through the WAN 1 using the policy based routing.

Here are the steps for the policy based routing: https://help.ubnt.com/hc/en-us/articles/360005460813-UniFi-USG-Policy-Based-Routing-

And after that you need to create the JSON file and here are the steps for it: https://help.ubnt.com/hc/en-us/articles/215458888-UniFi-Advanced-USG-Configuration


Therefore, my suggestion for the following function that can be easily adjusted by GUI:
The routing of the VPN from WAN2 to WAN1 via checkbox.


Is that possible?


Unfortunately, my skills are limited to the handling via GUI