Reply
New Member
Posts: 1
Registered: ‎11-12-2018

Unifi Controller 5.9.29 USG WAN2 Throughput Blank

Lightning zapped my USG3P WAN port, so I had to move everything over to LAN/WAN2.  This is working OK after figuring out how to disable the zapped WAN port via config.json and remapping my port forwards.

 

However, WAN2 throughput statistics are reported incorrectly:

ContTP1.JPG

 

Throughput is detected on WAN2 but reported as LAN2:

ContTP2.JPG

 

The USG WAN port is disabled and the WAN2/LAN2 port is configured as WAN:

USGports.JPG

 

Although I noticed that the USG properties collect the WAN2 statistics under a "WAN 1" umbrella:

USGwan1.JPG

 

Googling around the forae, looks like a lot of the WAN1/WAN2 failover and load balance cases fall into the same hole, it's just more obvious for me because my WAN port is totally borked.

 

Any ideas?

 

Thanks!

Reply