Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×

[FIRMWARE] 3.7.45.6182 for UAP-AC-HD has been released

by Ubiquiti Employee ‎03-08-2017 08:43 AM - edited ‎03-08-2017 08:44 AM (16,076 Views)

Hi all, 

 

We've prepared firmware 3.7.45.6182. Immediately, we've only released it for AC-HD and it has been pushed to controller 5.4.11. It will be released to for other devices at a later date. If you wish to try it on other devices now, then please see our blog post in the beta section. 

 

Firmware changes from 3.7.40:

  • [UAPG3] Enable airtime fairness (ATF) support.
  • [UAPG3] Enable DFS support for US/CA.
  • [UAPG3] Default disable 802.11w.*
  • [UAPG3] Backport offload firmware patches to improve performance.
  • [UAPG3] Enable powersave function, similar to 2nd gen implementation.
  • [UAPG3] Fix DFS scanning.
  • [UAPG3] Multicast improvements.
  • [UAP] Fix issue where connected STA may be improperly rate limited (UAP-50).
  • [UAP] Various 802.1X identity fixes.
  • [UAP] Fix provisioning issue causing mismatched VAP configs.
  • [UAP] Enable minimum rate control for all QCA UAPs.**
  • [UAP] Fix several node leaks.
  • [UAP] Fix a memory leak in the redirector.

 

*Will be able to change via the controller UI in a future update. It will either be able to be disabled, optional or required.

**This only excludes 1st gen AC (UAP-AC, UAP-AC v2, and UAP-AC-Outdoor). 

 

Notes:

If you have problems updating your AC-HD, or it doesn't come up after the update, then perform the following steps to resolve the issue:

  • Change both radios from auto to a fixed channel.
  • Factory default the AP (physical reset).
  • When it provisions, it will come up.

 

Download:

Cheers,

The UniFi team