[FIRMWARE] for UAP/USW has been released

by Ubiquiti Employee on ‎09-08-2017 09:00 AM (30,545 Views)

Hi all,


We've prepared firmware The AC/SHD firmware isn't present so we'd like you to continue to use the latest release-toronto build. We hope to have the Toronto firmware merged in the near future.


Please see below for the changelog and links to the firmware binaries.


Firmware changes from 3.8.11:

  • [ACG1] Add multi-block WLAN schedule support.*
  • [UAP] Add management VLAN support for wireless uplink.*
  • [UAP] Add options for RF scan (active/passive, background/foreground).*
  • [UAP] Add support for best channel suggestion after running RF scan.*
  • [UAP] Add support for fast-apply WLAN config, for existing WLANs only.
  • [UAP] Allow 80MHz for Russia country code.
  • [UAP] Remove iperf package, as it does not provide proper results when using an AP as an endpoint.
  • [UAP] Various security and backend fixes and/or improvements.
  • [USW] Add missing IPv4 multicast trap policy (due to code base upgrade).
  • [HW] Limit SSH username to 32 character length.

*controller support is pending.



Links are all HTTPS. This assumes your device(s) are currently running at least 3.7.51, and that the device's date is properly set (i.e. it can reach a NTP server). If you encounter issues with the upgrade, or your device isn't on a minimum supported firmware, then you can change the link to HTTP before performing the upgrade.


The UniFi team