[FIRMWARE] 3.9.42.9152 for UAP/USW has been released

by Ubiquiti Employee on ‎07-16-2018 08:14 AM (51,938 Views)

We've prepared firmware 3.9.42.9152. Please see below for the changelog and links to the firmware binaries. This is a stable candidate release which is currently available via the blog only.

 

Firmware changes since 3.9.40:

  • [nanoHD/IW-HD] Add VHT160 support for RF Environment scanning.
  • [nanoHD/IW-HD] Fix hidden SSID provisioning.
  • [nanoHD/IW-HD] Fix reported signal of neighboring APs (reported HERE).
  • [nanoHD/IW-HD] Fix an issue with TX power provisioning.
  • [nanoHD/IW-HD] Performance and stability improvements.
  • [IW-HD] Fix DVLAN issue. 
  • [USW] Fix RADIUS server provisioning.
  • [HW] Fix inform URL caching issue. 
  • [HW] Various bug fixes and improvements.
  • [SEC] Security improvement. It's a low/medium threat which was discovered internally. 

 

NOTE: You may start to see EVT_AP_RestartProc events in the controller log. If you see these, please report if there is anything specifically in your setup that triggers the events. The processes restarting is not new, but the reporting of the restarting is, and we are using these reports to clean up these issues.

 

IMPORTANT NOTE: In preparation for an upcoming code merge, we've updated the minimum firmware version to 3.9.42 for certain hardware. That means if you flash this firmware onto any HD/SHD/XG/BaseStationXG then you will not be able to downgrade to firmware prior to 3.9.42. 

 

Download:

*This firmware is meant to be a one file solution that works with all models of UniFi switch. You can use it when upgrading from 3.9.40+ only. It will not work when upgrading from earlier releases.

 

Any and all feedback is welcome, including lettings us know about successful device upgrades. When reporting an issue, please ensure that you include the following information:

  1. Controller version.
  2. Firmware version (previous and current). 
  3. Device model(s). 

Links are all HTTPS. This assumes your device(s) are currently running at least 3.7.51, and that the device's date is properly set (i.e. it can reach a NTP server). If you encounter issues with the upgrade, or your device isn't on a minimum supported firmware, then you can change the link to HTTP before performing the upgrade.