airCam (gen1) cameras are not supported in 3.2+. Please stick to the 3.1.x chain if you have airCams.
All Linux commands below are for the NVR appliance and Debian 7. Different Linux distributions will have slightly different commands.
Updating from a UniFi Video installation prior to 3.3.0 might take an hour or longer, depending on the amount of recordings in the database. To get up and running immediately, perform a clean install instead of upgrading.
Your Ubiquiti Account (SSO) is the same account you use to login to the community forum. If you want to use a different account for UniFi Video, first log out of the community before setting up UniFi Video for cloud access.
When adding a new camera, your camera password will be reset and configurable under NVR Settings. Username remains the same.
RTSP stream URLs have changed from 3.1.x.
Systems that are not the hardware NVR (airVision-C or UVC-NVR) should have some form of an NTP daemon installed.
Windows: Run Installer as Administrator
Hardware NVR/Linux Install via apt:
apt-get update; apt-get upgrade; apt-get clean
Hardware NVR/Debian Install manual installation (other Linux files are linked at the bottom of this post, simply change the URL and filename to the appropriate operating system):
If you restore from a backup, you will likely get a 400 error if/when attempting to set anything under Settings main page
When setting up alerts for a specific User, you may get an initial warning that alerts are not globally enabled even when they are. Click the link which will bring you to the global configuration alerts enabling, then go back to Alerts settings for the specific user and you’ll be able to enable/disable as desired
Schedules are only visible to the user that created them
Non-administrative users are shown the alerts tab but they cannot configure their alerts