Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×

UniFi Video 3.7.2 Release

by Ubiquiti Employee on ‎07-21-2017 01:32 PM

System Requirements

  • NVR appliance or a 64-bit OS from the Files section below
  • Intel Atom D2500 CPU
  • 100GB HDD
  • 4GB RAM
  • Google Chrome
  • 500GB HDD or larger

 

Important Notes

  • All Linux commands below are for the NVR appliance and Debian 7. Different Linux distributions will have slightly different commands.
  • Updating from a UniFi Video installation prior to 3.3.0 might take an hour or longer, depending on the amount of recordings in the database. To get up and running immediately, perform a clean install instead of upgrading.
  • Your Ubiquiti Account (SSO) is the same account you use to login to the community forum. If you want to use a different account for UniFi Video, first log out of the community before setting up UniFi Video for cloud access.
  • When adding a new camera, your camera password will be reset and configurable under NVR Settings.  Username remains the same.
  • Systems that are not the hardware NVR (airVision-C or UVC-NVR) should have some form of an NTP daemon installed.
  • Email and push alert enable/disable settings are now per-user instead of being system-wide. Alert settings can be found under the "Alerts" tab of each configured user.

Installation

  • Windows: Run Installer as Administrator
  • Hardware NVR/Linux Install via apt:
    apt-get update; apt-get upgrade; apt-get clean
  • Hardware NVR/Debian Install manual installation (other Linux files are linked at the bottom of this post, simply change the URL and filename to the appropriate operating system):
    wget http://dl.ubnt.com/firmwares/unifi-video/3.7.2/unifi-video_3.7.2-Debian7_amd64.deb
    sudo dpkg -i unifi-video_3.7.2-Debian7_amd64.deb 

 

 

Cloud Setup

New Installations

  • Visit https://video.ubnt.com using Chrome from a computer on the same network as your UniFi Video installation.

Upgrades

  • Connect to your NVR locally (over HTTPS using the server's IP address on port 7443), then click 'Connect To My Ubiquiti Account' under NVR Settings.

 

 

Change Log

Camera

No changes

 

EMS

No changes

 

Backend

  • Camera management protocol security fix
  • Omit camera password from logs

 

Web Application

No changes

 

 

KNOWN ISSUES

  • If you restore from a backup, you will likely get a 400 error if/when attempting to set anything under Settings main page
  • Schedules are only visible to the user that created them
  • Non administrative users are shown the alerts tab but they cannot configure their alerts
  • Port Forwarding/Custom Ports
  • If not using Cloud login, please check this article for required open ports and customizing ports

 

 


 

Files

*Cloud functionality is peer-to-peer. All video is encrypted and not stored on our servers.

**These are the only officially supported Windows operating systems