** In order to improve the security of camera communication, cameras will now connect to the controller using port 7442 instead of the web UI port (7443) **
Cameras running pre-3.8 firmware will be allowed to connect via port 7443 to be discovered and initiate software upgrade, but will only be allowed to fully connect over port 7442 (upgraded cameras should connect via 7442 after upgrade)
Any network configurations that define special rules for forwarding port 7443 for camera connections will need to be adjusted, adding port 7442 as allowed/forwarded to the server with UniFi Video installed.
The system property app.cam.https.port can be used to change the camera connection port. But app.cam.https.port and app.http.port (used to connect to the controller web UI) cannot be configured to use the same port number. The configured port cannot be a port already in use by UniFi Video or any other service running on the computer.
All Linux commands below are for theNVRappliance and Debian 7. Different Linux distributions will have slightly different commands.
Updating from aUniFiVideo installation prior to 3.3.0 might take an hour or longer, depending onthe amount ofrecordings in the database. To get up and running immediately, perform a clean install instead of upgrading.
YourUbiquitiAccount (SSO) is the same account you use tologinto the community forum. If you want to use a different account forUniFiVideo, first log out of the community before setting upUniFiVideo for cloud access.
When adding a new camera, your camera password will be reset and configurable underNVRSettings. Usernameremains the same.
Systems that are not the hardwareNVR(airVision-C orUVC-NVR) must have some form of anNTPdaemoninstalledinstalled to prevent timestamp and time synchronization errors.
Email and push alert enable/disable settings are now per-user instead of being system-wide. Alert settings can be found under the "Alerts" tab of each configured user.
Although downgrading is not technically supported, if you do choose to downgrade from a version below 3.8.0, you'll need to factory default your cameras while on firmware less than 3.8.0in order for the cameras to be managed by controllers less than 3.8.0. i.e. Downgrade the controller, make sure the firmware on the camera has downgraded to something lower than 3.8.0 (3.7.0 for example), factory default the camera, manage the camera.
Windows: Run Installer as Administrator
HardwareNVR/Linux Install via apt:
apt-get update; apt-get upgrade; apt-get clean
HardwareNVR/Debian Install manual installation (other Linux files are linked at the bottom of this post, simply change the URL andfilenameto the appropriate operating system):