Reply
New Member
Posts: 4
Registered: ‎03-12-2018

G3 Flex wont power up on US8-60W Switch

New US 8-60W Switch

New G3 Camera

New G# Flex Camera

 

All new from Unifi.   Adopted US8-60W on Unifi Controller and updated Firmware,  Green - Operating Fine

 

Connected G3 Camera to port 5,  Operating Fine on Unifi NVR

 

Connected G3 Flex to same port with same wire,   Nothing/Dead/No Power   ????

 

Thanks

Established Member
Posts: 969
Registered: ‎02-12-2013
Kudos: 249
Solutions: 90

Re: G3 Flex wont power up on US8-60W Switch

@larryl6969
Do you have a PoE adapter? Then try to see if there's life - otherwise it's probably a bad unit and you should return it and get a new.
New Member
Posts: 4
Registered: ‎03-12-2018

Re: G3 Flex wont power up on US8-60W Switch

no adapter,   got RA sending back

 

thanks

Ancient Member
Posts: 32,664
Registered: ‎05-05-2012
Kudos: 10449
Solutions: 1619

Re: G3 Flex wont power up on US8-60W Switch


@larryl6969 wrote:

Connected G3 Camera to port 5,  Operating Fine on Unifi NVR...


The original G3 was 24V passive only so I assume you mean the G3-AF and that there was not a PoE injector or Instant AF converter inline?  If you used an injector, the PoE might have been manually turned off on port 5.

 

If you used an Instant AF converter with the G3, it should be removed and the G3-Flex connected directly.

Highlighted
New Member
Posts: 4
Registered: ‎03-12-2018

Re: G3 Flex wont power up on US8-60W Switch

it was a new G3-AF with no injector

 

G3 Flex wont power up on any port

 

thanks

Reply