Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×
Reply
Highlighted
New Member
Posts: 11
Registered: ‎12-18-2015
Kudos: 1
Solutions: 1

AC Pro reverts back to prior controller

I have a site where an AC Pro randomly reverts back to the IP address of a prior controller. That controller is no longer in service. The quick fix is to log into the AC Pro and send the set-inform command. The WAP reappears were it should, provisions and is happy. Per CLI I resend the set-inform command again. Firmware updates have not addressed this issue. Has someone else seen this behavior?

 

Thank you in advance.

 

Guy

SuperUser
Posts: 15,315
Registered: ‎06-18-2010
Kudos: 4590
Solutions: 1608

Re: AC Pro reverts back to prior controller

Try a reset to defaults first, then the set-inform; adopt; set-inform tango
Hi, I'm @flipper, member of the Ubiquiti Community, and I am Not a Bot
Reply