New Member
Posts: 16
Registered: ‎12-18-2015
Kudos: 1
Solutions: 1

AC Pro reverts back to prior controller

I have a site where an AC Pro randomly reverts back to the IP address of a prior controller. That controller is no longer in service. The quick fix is to log into the AC Pro and send the set-inform command. The WAP reappears were it should, provisions and is happy. Per CLI I resend the set-inform command again. Firmware updates have not addressed this issue. Has someone else seen this behavior?


Thank you in advance.



Posts: 16,223
Registered: ‎06-18-2010
Kudos: 5117
Solutions: 1714

Re: AC Pro reverts back to prior controller

Try a reset to defaults first, then the set-inform; adopt; set-inform tango
I did it my way .... Man Happy