Reply
Highlighted
New Member
Posts: 10
Registered: ‎07-12-2017

SNMP on my UniFi AP-AC v2 version 3.8.15.6784 doesnt show all counters it should

hi,

in my network i have several UniFi AP-AC v2 with FW version 3.8.15.6784.

I was trying to get usign SNMP v1 (only available) the number os Users (devices) connected.

 

from the MIB (UBNT-UniFi-MIB) i expect that the IODs:

- 1.3.6.1.4.1.41112.1.6.1.2.1.8.3 (for clients 5g)
- 1.3.6.1.4.1.41112.1.6.1.2.1.8.2 (for clients 2g)

 

return me a value, but it doesnt. Even from an snmpwalk i can't get them.

 

is it a firmware problem or the APs are too old ? (even if snmp its just a matter of OS)

 

regards

Luca

 

Senior Member
Posts: 2,713
Registered: ‎08-06-2015
Kudos: 1155
Solutions: 155

Re: SNMP on my UniFi AP-AC v2 version 3.8.15.6784 doesnt show all counters it should

The UBNT MIBs are only supported on gen 2 and later UAPs.  The Gen 1 UAPs, including the original square UAP-AC, do not support these.

 

SNMP is supported on the gen1 but only with a smaller set of MIBs.

Reply