11-08-2018 02:43 PM
I've recently purchased a Unifi Setup and I am starting to transfer everything over to the AP. I can't seem to get my cameras to work on this Unifi AP. So this could be something simple I'm overlooking so feel free to make any suggestions to me. I did try the standard reboot
The AP shows the camera is connected and that it has an IP. But if I try to go to that IP to view the firmware or stream directly it times out. If I look on the app/website that supports the camera it shows the camera as online but when you try to view the stream it never comes up nor can you get to the settings page etc.
Thanks for any help it is much appreciated.
11-08-2018 02:49 PM
No the camera is connected to the main network all of my other devices are connected to. I also just went to check to make sure I didnt' make my network a guest network and the check box (under guest network) is not there.
11-08-2018 02:59 PM
Yes I left everything that was defaulted to on.
Here are the settings I have enabled
Block LAN to WLAN Multicast and Broadcast Data
Enable GTK rekeying every 3600
I also selected to block the SSID from being broadcast but that's just as a security measure.
11-08-2018 03:42 PM
This appears to have fixed the problem. Thank you for your assistance.
I may have checked the option (block lan to wlan) since it says its reccomended to turn it on. But I don't see why I would have checked the GTK Rekeying. Is it safe to turn that off the GTK rekeying as well?
Thank you again.
11-08-2018 04:06 PM
No problem. My last house had 14 cameras around the perimiter of the house and around the property. We don't need them where we live now, but it is fun to watch the livestock and such here, especially the little Nigerian Dwarf goats.