Reply
Senior Member
Posts: 3,279
Registered: ‎07-28-2009
Kudos: 975
Solutions: 44

URGENT BUG: 2.1.1B2 - Check UNMS Status stops graphing for device

@UBNT-Karolis - I just installed the public 2.1.1b2 AC2 and I right clicked on 2 APs in my system. I went to More -> UNMS -> and checked Update Status.  After I did that on both APs neither AP is graphing data any more in the charts.

Senior Member
Posts: 3,279
Registered: ‎07-28-2009
Kudos: 975
Solutions: 44

Re: URGENT BUG: 2.1.1B2 - Check UNMS Status stops graphing for device

On on AP that I did the status check on (this AP is in UNMS) I was able to get the charts working again by stopping monitoring and and starting monitoring again.

 

On the other AP that I did the status check on (this AP is NOT in UNMS), stopping and starting monitoring did not fix the charts at first.  I had to leave it with monitoring off for a couple of minutes and then after starting monitoring again it started charting.

Senior Member
Posts: 3,279
Registered: ‎07-28-2009
Kudos: 975
Solutions: 44

Re: URGENT BUG: 2.1.1B2 - Check UNMS Status stops graphing for device

Same thing happens when I check UNMS status on a CPE as well.  After the status update the graphs stop working until I Stop/Start monitoring.  This is on the Desktop client.

Ubiquiti Employee
Posts: 766
Registered: ‎05-28-2012
Kudos: 391
Solutions: 79

Re: URGENT BUG: 2.1.1B2 - Check UNMS Status stops graphing for device

@sbyrd I can acknowledge the bug exists. I believe I fixed it and will do a Beta3 release shortly.

Reply