ac2 doesn't recognize "auto" in MAX TX DATA RATE when in Mass Config

[jjdperryman]

I wanna make sure all my connected radio's are in auto but when I am going through and making mass config changes, it's not letting me select "auto"?

Latest version of AC2, Most of my radio's are using 6.1.7, a few at 6.1.9, and one each of 8.5.7 and 8.5.11. 

I'm afraid to upgrade to the latest on a few of these devices since we've been having some issues with the 8.5.x updates (stuff we are still trying to work out, test, etc.)

[UBNT-Karolis · Accepted solution]

Hi @jjdperryman ,

this is a bug with mass configuration, it should not allow configuring mx rate for M and AC series devices together. Configuration values for different product series are simply incompatible. Fix for this will be available in the next release.

[jjdperryman]

The radio that is throwing off the -1 is the PowerBeam 5AC Gen2 using 8.5.11. Going to try downgrading to 8.5.7 to see what it kicks back.

[jjdperryman]

Upgrading that one firmware didn't help, still -1. BUT I did just log into the web version of ac2 and it didn't force me to make a selection there, It allowed me to keep them at << differs >> unlike the ac2 program which was forcing me to make a change. So I made the other changes I wanted and I will come back down the road and see if anyone has suggestions/ideas here.

[UBNT-Karolis · Accepted solution]

Hi @jjdperryman ,

this is a bug with mass configuration, it should not allow configuring mx rate for M and AC series devices together. Configuration values for different product series are simply incompatible. Fix for this will be available in the next release.

[jjdperryman]

@UBNT-Karolis, Thanks for the info!