Reply
Highlighted
Emerging Member
Posts: 95
Registered: ‎01-05-2015
Kudos: 5
Accepted Solution

changing coords and map

Using Beta 9 I am working through hardware, select it then configure and add the coordinates if they are missing. Apply that and they do get added however it does not change the location on the map to the correct position. Doesn't seem to matter what the hardware is or software version on it.

 

tk


Accepted Solutions
Veteran Member
Posts: 4,475
Registered: ‎03-02-2015
Kudos: 855
Solutions: 199

Re: changing coords and map

Select devices which are wrong on Map and right-click  'reset position modifications'

===================================================
We all work for KUDOs here.
Thx

View solution in original post


All Replies
Veteran Member
Posts: 4,475
Registered: ‎03-02-2015
Kudos: 855
Solutions: 199

Re: changing coords and map

Select devices which are wrong on Map and right-click  'reset position modifications'

===================================================
We all work for KUDOs here.
Thx
Ubiquiti Employee
Posts: 711
Registered: ‎05-28-2012
Kudos: 361
Solutions: 76

Re: changing coords and map

@tlkhorses if you manually moved device on the map view, it will save that user defined location and will use it instead of one reported by device. You need to select those devices on map and do reset position, this will take location from device.

Emerging Member
Posts: 95
Registered: ‎01-05-2015
Kudos: 5

Re: changing coords and map

Ok, I would have thought that if you manually entered the coordinates, it would automatically move the unit on the map.

 

tk

Reply