Reply
Highlighted
New Member
Posts: 4
Registered: ‎05-08-2017

Problem with device-name in automation rules

Hi, i'm experiencing and error with automation rules.

 

I have several devices under monitoring, for example: Device-A, Device-B, Device-C, Device-D.

 

I've setup a rule for each one that check the link capacity (download and upload) and, in case the value falls below a certain threshold, sends an email reporting the device name and what happened:

 

Device-name = Device-A

and

Capacity-uplink @ wlan current < 10 Mbps

or

Capacity-downlink @ wlan current < 10 Mbps

Send e-mail

 

The problem is that if device A trigger the rule, i receive e-mail from rules "Device-B" and "Device-C". But not from D and others.

In the wrong e-mail i can see that the rule set for, for example, Device-B on "Device-X" has been triggered by "Device-X"...

I double checked the settings in that rule (Device-B), but "Device-X" is not mentioned anywhere...

 

Where is the problem? Where can i check?

 

Thanks.

 

Veteran Member
Posts: 4,749
Registered: ‎03-02-2015
Kudos: 919
Solutions: 214

Re: Problem with device-name in automation rules

can you post a screenshot of your rule?
===================================================
We all work for KUDOs here.
Thx
New Member
Posts: 4
Registered: ‎05-08-2017

Re: Problem with device-name in automation rules

I captured the problem.

 

Here you can see that the rules are triggering in the wrong device:

 

1.png5.png

 

And here you can see the rules:

 

2.png

 

3.png

 

4.png

 

Every rule, when triggered, send an email.

Reply