07-01-2018 06:20 AM
Port forwarding has now been added to the current firmware but it only supports forwarding individual ports and not port ranges. Please add support to forward port ranges in the next firmware version.
4 weeks ago
Is there anything on the product timeline to address this range limitation, as well as request you add DMZ. Also from UNMS (0.12.1) if you try and save more than 4 Port Forwards you get an error. If you add them directly in the Aircibe you can add without issue more (I got up to 8 as a test). When you go back to the UNMS you can see them but you can't remove them, then if you remove them from the Aircube the UNMS will try to add one but after the update refreshes the add doesn't take (at least its not visible on the screen), reboot the Aircube and viola its there. There seems to be a disconnect between the unms and the Aircube for Port Forwarding.
Just discovered a significant bug with port forwarding where it only works for DHCP assigned addresses and not when these are statically assigned. When we offer VOIP service to customers, we normally configure our ATA adapter with a static internal IP address outside the DHCP pool range to ensure the internal IP address does not change when doing port forwarding or QoS.
Port forwarding using any other type of router works fine with a configuration like this but not with the airCube. After much trial and error, we finally realized that port forwarding does not work on non-DHCP assigned IP addresses which should not be the case.
Please correct this issue in the next firmware update.