Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×
Reply
New Member
Posts: 8
Registered: ‎06-19-2017

NanoBeam AC, EdgePiont R6 - VPN

[ Edited ]

Hello.

I have two localisations conected by R6 EdgePoint. I configure R6 as switch (I don't know if it is good)ubiquiti.jpg

After Nanoeam are users and on another site is server. How protect this network. I need VPN to remote connect. Thanks.

Please tell me is correct that i configure R6 as Switch?

Highlighted
New Member
Posts: 19
Registered: ‎08-29-2016
Kudos: 26

Re: NanoBeam AC, EdgePiont R6 - VPN

Hello,

 

I have the same setup, EPR6 as a switch and everything is fine.

Member
Posts: 290
Registered: ‎09-21-2014
Kudos: 27
Solutions: 4

Re: NanoBeam AC, EdgePiont R6 - VPN

How to set EPR6 as a Switch?
So, don't I need to use EPS16 when I need a swtich?

UACA & UEWAv2 Certified
Mikrotik Certified Consultant
MTCNA, MTCRE, MTCWE, MTCTCE, MTCUME, MTCINE, MTCIPv6E
New Member
Posts: 19
Registered: ‎08-29-2016
Kudos: 26

Re: NanoBeam AC, EdgePiont R6 - VPN

[ Edited ]

You can use the "switch" Wizard in Wizards tab and enable vlan if needed.

EPR6 is a router but it can be setup as a switch (no problem), you add the interface to the switch interface it creates.

 

Capture6.PNG

 

Capture7.PNG

New Member
Posts: 8
Registered: ‎06-19-2017

Re: NanoBeam AC, EdgePiont R6 - VPN

Ok - thanks for reply. 

1. Can i use traffic analitycs when i use switch

2. How can i protect this network? To roter Edge Point with VPN. tunel?

Reply