07-12-2018 08:06 PM
Got a pair of old M2HP16 AirGrids been working great for years. Will be upgrading to the LiteBeams AC Gen2s however I want to try and squeeze as much as I can out of this link for as long as possible. Link only 180M or so but its a little strange. Direct sight.
Had speed test between two devices on duplex at around 75 - 79mbps. Ran internet speed test on host its 95/35mp but on client only around 9mb/9mb tops. Strange thing was a week ago when I made the sender the receiver and the receiver the sender it started as a solid 45/55mb download but now cant get over 9mb. Pics attached of setup. hoping someone can help
07-12-2018 09:55 PM
07-13-2018 08:47 AM
Change your channel width to 20Mhz and double check your alignment. You should have a much better signal than you do. If your alignment is okay, turn your output power up to get around a -55 signal.
07-17-2018 12:11 AM
Hi - Thanks for the reply!
I decided to upgrade to the LBE-5AC-GEN2 and getting a solid 600mb throughput. Same 250M line of sight and perfect speed results between antennas. I still only get 9 / 10mbps on speed test upload & download. I feel the Modems at either end will have to be the culprit for the low speeds. The host end has a NetGear r7000 and wireless and wired tests through that get full 100/40mbps speed test results. The reciving end I have a TL-WDR4300 n750 and thats where the slow speeds are, wireless and wired. Perhaps upgrading that would be the fix? I already have the latest firmware, just not allowing the full speeds
07-17-2018 12:27 AM
07-17-2018 01:47 AM
Bypassed the TL-WFR4300 and still got same test results. I could try and use a different router other thatn the r7000 however thats one of the best routers out there for the moment
ANy more ideas ?
http://www.speedtest.net/result/7476879938.png – is speed test – maxxed at 10 ??
https://imgur.com/a/PAEKPMG – screenshot of report
https://imgur.com/a/DsVAqR1 – the in built speed tests
https://imgur.com/a/2UQdWj2 – screen of web interface.
07-17-2018 09:01 AM
07-18-2018 01:35 PM - edited 07-18-2018 01:37 PM
Start where ever you are getting a full speed test result, then step back one point of connection at a time until you find where the speed drops to 9Mb. Once you find where this is you will know the problem is between this point of connection and the previous point tested.