New Member
Posts: 4
Registered: ‎07-25-2018

Nanostatation M2 point to point high latency

At the sending end I am getting 10 ms ping and 32 Mbps but at the other end of my bridge I am getting 2 Mbps and over 300 ms many times to high ping to test. I keep trying yo switch setting but nothing seems to be working for me. Any ideas?

2019-05-16 (1).png
2019-05-16.png
Senior Member
Posts: 23,729
Registered: ‎08-04-2017
Kudos: 4489
Solutions: 1167

Re: Nanostatation M2 point to point high latency

Hello @UBNT-JaM,

 

Could you move this to AirMAX?

 

 

Regards,

Glenn R.

Cloud Hosted Controllers | Glenn R. | UniFi Installation/Easy Update Scripts | UniFi-Video Installation Scripts | UniFi-VoIP Installation Scripts
USG-XG-8 • USG-4-PRO • USG
US-XG-16 • US-48-500W • US-24-POE-250W 2x • US-16-POE-150W 3x • US-24 • US-8-150W • US-8
UAP XG • UAP-SHD • UAP-HD • UAP-NanoHD 2x • UAP-AC-PRO 2x • UAP-AC-LITE • UAP-AC-IW • UAP-AC-M • UAP-AC-M-PRO 2x
UAS-XG • UCK-G2-PLUS • UCK-G2 • UCK
Veteran Member
Posts: 5,049
Registered: ‎03-02-2015
Kudos: 1002
Solutions: 230

Re: Nanostatation M2 point to point high latency

@mchase1134

Nanostation has to little bit to low gain for this distance.
i would suggest to enable airmax on your AP.
===================================================
We all work for KUDOs here.
Thx
Senior Member
Posts: 3,479
Registered: ‎07-17-2010
Kudos: 824
Solutions: 199

Re: Nanostatation M2 point to point high latency

[ Edited ]

As @Skipper0815  suggested, enable Airmax (on the first tab of the AP).

 

At this distance your signal should be better. Get the radios aligned and up in the clear.

 

Next, run airview to find the cleanes spectrum.

 

Reduce channel width to 10 MHz and manually set channel to the cleanest spectrum.