Emerging Member
Posts: 51
Registered: ‎09-06-2017
Kudos: 6
Solutions: 1
Accepted Solution

Output power

Weird. I just updated my NanoBeam Gen2 to the latest firmware (8.5.11-CS). But the max output power i can apply is 1dbm. Before i can set it to max power. but now, it is stucked to 1dbm. Anyone here experiencing same problem? 

Capture.JPG

Accepted Solutions
Emerging Member
Posts: 51
Registered: ‎09-06-2017
Kudos: 6
Solutions: 1

Re: Output power

Found the solution. Calculate EIRP Limit is moved on the bottom. Setting it to off can now adjust the output power. 

View solution in original post


All Replies
Emerging Member
Posts: 51
Registered: ‎09-06-2017
Kudos: 6
Solutions: 1

Re: Output power

Found the solution. Calculate EIRP Limit is moved on the bottom. Setting it to off can now adjust the output power. 

Ubiquiti Employee
Posts: 11,657
Registered: ‎04-14-2017
Kudos: 2166
Solutions: 335

Re: Output power

Please make sure you are operating within your local limits.
Highlighted
Emerging Member
Posts: 51
Registered: ‎09-06-2017
Kudos: 6
Solutions: 1

Re: Output power

duly noted.