12-05-2018 09:30 AM
Hi guys. I am trying to set up a point to point connection in London. The two units I have tried my best to align but I think the problem is to much interference and foliage in the way. Could some one point me in the right direction? I am trying to send 300mbps to another site via power beam M5.
I have also included my settings. Am I not putting in enough dbi? The dishes say 27dbi but I can only set 9dbi.
12-05-2018 10:34 AM - edited 12-05-2018 10:36 AM
That picture is very blurry. Is that the other dish I see?
If that is the other dish than you ave an alignment issue, as that should work, even if not perfect.
Start with a 10 or 20 MHz channel width and work on alignment.
The dish is 27dbi gain. Your tx power is limited, likely by your local regulations.
12-05-2018 11:45 AM
12-05-2018 12:51 PM
Hi thanks for the reply.
The picture I have taken through a set of binoculars.
The sender dish is lower than the receiver dish. Do you think I should get two people at each end ? It's very difficult to align as the dishes are mounted high on a pole to get maximum reach over the buildings.
Please see the type of terrain it is over. It is all city buildings and housing.
12-05-2018 01:01 PM
I have never used air view scan but I certainly will do this.
Do you think it's ok going through or near to a building that has telecoms dishes on to ? I have attached a picture of what it is passing further back from the magnified picture I originally posted.
12-06-2018 06:41 AM
there is a very nice app for allignment for android called " SICE airghz radio link wifi . it has helped me in many occasions
12-06-2018 12:50 PM