Scheduled maintenance: Community will be offline Monday June 17th, 1:00 AM - 6:00 AM (PT)
New Member
Posts: 1
Registered: ‎10-04-2016

Powerbeam M5 - default password not workimg

New installation of PowerBeam M5.  Tried logging in with ubnt/ubnt and admin/ubnt credentials in a browser , no good.  Used Putty with the same credentials as stated above, same result.  I also tried root/admin, no successful.

 

Preformed a hard reset as well. NG.

 

I would appreciate any help to resolve this issue .

 

Thank You

DFrey

SuperUser
Posts: 16,859
Registered: ‎06-18-2010
Kudos: 5422
Solutions: 1803

Re: Powerbeam M5 - default password not workimg

[ Edited ]

Your 'hard reset' didn't take. Hold the button firmly for longer.

ubnt/ubnt are the factory default credentials.

 

It's possible the Powerbeam was previously configured to disable the reset button. TFTP mode is your way out:

 

https://help.ubnt.com/hc/en-us/articles/204911324-airMAX-How-to-Reset-Your-Device-with-TFTP-Firmware...

Set a Frequency! Don't leave it on Auto!
Disable Uplink Connectivity Monitor
Always set-inform a Second time after Adopting