Reply
New Member
Posts: 2
Registered: ‎11-27-2018
Kudos: 1
Solutions: 1
Accepted Solution

Rocket 5AC Prism setup

We are using these devices to connect two managed switches together.  They are a Brocade FWS648G and an Cisco C2960x.  Both interfaces are setup as trunk ports, and the Ubiquiti devices are setup in bridge mode to pass all traffic.  However, I still cannot ping the Ubiquiti devices from across our network.  Any ideas?


Accepted Solutions
Highlighted
New Member
Posts: 2
Registered: ‎11-27-2018
Kudos: 1
Solutions: 1

Re: Rocket 5AC Prism setup

Everything was setup correctly on the Ubiquiti devices. The problem ended up being a VLAN pruning issue. The management VLAN was being blocked on one of the uplink interfaces. Dumb mistake on my part.

View solution in original post


All Replies
Ubiquiti Employee
Posts: 11,275
Registered: ‎04-14-2017
Kudos: 2091
Solutions: 323

Re: Rocket 5AC Prism setup

Can you post your network setup?
Highlighted
New Member
Posts: 2
Registered: ‎11-27-2018
Kudos: 1
Solutions: 1

Re: Rocket 5AC Prism setup

Everything was setup correctly on the Ubiquiti devices. The problem ended up being a VLAN pruning issue. The management VLAN was being blocked on one of the uplink interfaces. Dumb mistake on my part.
Reply