Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

Airgrid AG-HP-2G16 installation on farm

My first experence with Ubiquiti and setting up two AG-HP-2G16's to extend an internet conection has been a complete success. I mounted the equipment and configed it myself. It was very easy and I cant believe I had not come into contact with this type of gear sooner. The distance was about 700 feet through a forest and though certainly not ideal link conditions it seems to be working very well.



‎04-18-2015 11:34 AM - edited ‎04-18-2015 11:40 AM

Nice, do you have any screen shots of the main tabs?

by Ubiquiti Employee
on ‎04-18-2015 11:39 AM

JLBTech, I'm glad it went so well - and thanks for sharing.

on ‎04-18-2015 01:22 PM

 I will get some screenshots of the main tabs next time I pick up a share at this farm.

on ‎04-20-2015 03:33 AM

I think, your feed was mounted in a wrong polarisation. The grid is mounted in vertical polar, but the feed is in horizontal.

If you change the feed polarization, you get a better signal Man Happy

on ‎04-20-2015 04:57 AM
Both ends of the link must be in the same polarity, the airgrid has the advantage of changing polarity to horizontal or vertical, it work better depending on the case.
However this badly mounted. For the polarity that has the grid, the ap have that it will stay in the side and the Ethernet output down.
With this equipment you can reach 30 mb/s without any problems
on ‎04-20-2015 05:21 AM

Thanks for pointing this out 

‎04-20-2015 09:11 AM - edited ‎04-20-2015 09:12 AM

the polarization is corrected indicated by the grid and feed horn orientation but it looks like 1 of the grids is upside down.

this will not affect performance but could significantly shorten the life of the grid if water gets in there but I think this is

an optical illusion based on the bracket gaps