Reply
Highlighted
Member
Posts: 120
Registered: ‎07-18-2014
Kudos: 13
Solutions: 6

NanoStation Loco M2 suddenly at RX: 1 mbps

Have a bridge between two buildings..quite close together, Lost the original radios in a lightning strike, replaced them about 2-3 weeks ago with configuration backups. Have been running fine since install,

 

Today suddenly the station side shows TX/RX 300mbps/1mbps, I cant tell if this is the station side or the AP side. 

Station Side

StationSide.png

 

AP Side

APSide.png

Ubiquiti Employee
Posts: 8,674
Registered: ‎04-14-2017
Kudos: 1634
Solutions: 249

Re: NanoStation Loco M2 suddenly at RX: 1 mbps

That is odd. What do you get if you run a traffic test between these radios?
Member
Posts: 120
Registered: ‎07-18-2014
Kudos: 13
Solutions: 6

Re: NanoStation Loco M2 suddenly at RX: 1 mbps

[ Edited ]

I thought maybe it was because I hadnt locked the replacement radio to the new AP MAC (no good reason to susepct this but it was bothering me), but now I've completely lost connection after comitting that change.

I'll update tomorrow after I have a lift available to access the radio.

Regular Member
Posts: 398
Registered: ‎11-13-2017
Kudos: 108
Solutions: 11

Re: NanoStation Loco M2 suddenly at RX: 1 mbps


@ParkIT wrote:

I'll update tomorrow after I have a lift available to access the radio.


You know there is reset button on PoE power adapter, so you need access only PoE adapter, not radio itself.

Reply