Reply
Highlighted
Regular Member
Posts: 567
Registered: ‎01-05-2009
Kudos: 65
Solutions: 10

Connecting mPower to controller

mFi 2.1.11

mPower 2.1.11

 

I'm having difficulty connecting my mPower to the controller. They are not on the same broadcast domain, so they aren't seeing each other. The mFi user guide says I can set the controller address in the initial setup, but I am very far away from this equipment, so resetting the mPower configuration is not an option.

 

Is there a command or anything I can use to connect the mPower to the controller without putting them on the same layer 2 network?

db
Reply