Upcoming Maintenance Alert:

The UBNT Community will be upgraded at 5pm MDT on April 25th. During this time the community forums will be set to read-only status.

Learn more

×
Reply
Highlighted
New Member
Posts: 16
Registered: ‎01-03-2016
Kudos: 2
Solutions: 1

mPower Pro IP change

Hello.

I have 4 mPower Pro 8-outlet PDUs which I can see with mFi Controller 2.1.11. However, they're on the default IP address of 192.168.1.20, which is different than the LAN network they're on.

 

Is there any way to set theses remotely? The colo is in another state.

They've been freshly reset to factory default, however they're stuck on "Adopting" status.

 

Thanks.

Reply